Recording - Onkyo MD-105TX Instruction Manual

Recording

Analog recording
Recording analog data (data input via the
connected audio pin cable)
1
Press the STANDBY/ON button.
The STANDBY indicator goes out.
2
Load a recordable MD.
MINIDISC RECORDER
STANDBY / ON
CD
DUBBING
STANDBY
INPUT REC MODE
Number of recorded
tracks on MD
Note
When "Protected" is shown in the display, it
indicates that the record-protect tab of the
MD is open. Before starting the recording
procedure, close the tab. (See page 34.)
24
STANDBY/ON
MINIDISC RECORDER
STANDBY / ON
CD
DUBBING
STANDBY
INPUT REC MODE
INPUT REC MODE
STANDBY/ON
STANDBY
AMCS
PUSH TO ENTER ( )
REC
DISPLAY EDIT / NO YES
MD- 105 TX
Insert an MD with the label
side up, in the direction of
the arrow.
Total recorded time
AMCS
( PUSH TO ENTER )
REC
DISPLAY EDIT / NO YES
MD- 105 TX
To check the time remaining for
recording
When the MD recorder is stopped, press the
DISPLAY button. Each press of the DISPLAY
button changes the display as follows:
The number of tracks on MD and the total
recorded time Remaining recording time on
MD Disc name ("No Name" when not set)
To record by erasing all of the existing
tracks on a prerecorded MD
Erase all the tracks before you start
recording (see page 36).
3
Press the INPUT button repeatedly
until "Analog In" appears.
INPUT
ANALOG IN
Note
• Make sure that the INPUT button and the
REC button on the amplifier are set to an
appropriate recording source.
4
Select a recording mode.
Refer to Step 4 on page 22 to select a
recording mode.
REC MODE
5
Play the recording source.
If a CD player (such as the C-705TX) or a
tape player (such as the K-505TX) has
been connected to the system, start
playing the CD or tape player.