GE GFWR4805 Owner's Manual & Installation Instructions page 9

GEAppliances.com
Add
Steam
Add Steam
Add Steam adds steam into the washer
early in the cycle to assist with loosening
stains on the Towels/Sheets, Normal,
Whites, Bulky, Active Wear, Power
Clean, Sanitize or Allergen cycles.
To use:
1. Turn power ON and select a wash
cycle. The Add Steam option is only
available on Towels/Sheets, Normal,
Whites, Bulky, Active Wear, Power
Clean, Sanitize or Allergen cycles.
2. Select the Add Steam button to
activate steam.
3. Press the Start/Pause button.
Hold 3 seconds to CANCEL
(Delay Wash)
Delay Wash
You can delay the start of a wash cycle
for up to 2/4 hours. Press the Delay
Wash button to choose the amount
of time you want to delay the start of
the wash cycle. Once the desired time
is reached, press the Start button. The
machine will count down and start
automatically at the correct time.
NOTE: If you forget to fully close the
door, a reminder signal will beep
reminding you to do so.
NOTE: If you open the door when the
delay is counting down, the machine will
enter the pause state. You must close
the door and press Start again in order
to restart the countdown.
iliSetter
I
Good
e Monitor
f
eHonitor (on some models)
The eNonitor lights display the relative
energy use of your selected cycle and
options. They are provided as an energy
guide and range from Good (1 light) to
Better (5 lights).Some special cycles will
not provide a display.
N-I-I I-I cyo,o
Complete Ci.Ci Ci
Extra Extra
Fil{_ Wosh_ Droin_ Rinse_ Spin_
Display
Displays the approximate time
remaining until the end of the cycle.
NOTE:The cycle time is affected by how
long it takes the washer to fill. This depends
on the water pressure in your home. The
"smart" timer "learns" the amount of time .
it takes to fill your washer and adjusts the
total time accordingly.
Cyclestatus isalso displayed and certain
features such as Delay Wash or Steam are
shown indicating they have been selected.
In addition, the display will, "scroll" the
washer status:
o
o
dOOr The washer door is open,
causing the machine to be in PAUSE
mode until the door is properly closed.
LOAd SenSE Sensing load size prior to
fill (normal operation). Cycles that do
not perform LOAD SENSEare Active
Wear, Delicates, Speed Wash, Single
Item, Rinse & Spin and Basket Clean.
PAUSE Cycle paused because the
Start/Pause or Add a Garment button
was pressed and the washer was set
to Pause. Press Start button again to
restart the cycle.
End End of current cycle.
OFF Washer is shutting down. The
washer may need to drain the water
prior to unlocking the door and shutting
down.
9