Lubrication; Greasing The Bearings And Bushings - Toro 30644 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose lithium-base grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 37
Figure 38
(Figure 37)
(Figure 38)
(Figure 39)
(Figure 39)
(Figure 39).
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
Latch pivot (2) (Figure
Note: The latch
(Figure
to gain access to the grease fitting. Use a prybar to close and
re-open the latch
1. Latch
39
Figure 39
41)
40) may need to be manually tripped
Figure 40