Product Overview; Controls - Toro 30644 Operator's Manual

Product Overview

Controls

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
This machine produces sound levels in excess of 85
dBA at the operators ear and can cause hearing loss
through extended periods of exposure.
Wear hearing protection when operating this
machine.
Traction Pedal
To stop, reduce your foot pressure on the traction pedal and
allow it to return to the center position
1. Brake pedals
2. Pedal locking latch
3. Parking brake latch
4. Space for optional
accessory
5. Beacon switch (optional)
Brake Pedals
Two foot pedals (Figure 3) operate individual wheel brakes
for turning assistance, parking, and to aid in obtaining better
side hill traction. A latch connects the pedals for parking
brake operation and transport.
Pedal Locking Latch
The pedal locking latch (Figure
together to engage the parking brake.
(Figure 3).
9
10
g020756
Figure 3
6. Hazard light switch
7. Turn signal switch
8. Horn button (optional)
9. Traction pedal
10. Tilt steering lever
3) connects the pedals
Tilt Steering Lever
Press the lever (Figure
to the desired position. Then release the lever to lock the
adjustment.
Parking Brake Latch
A knob on the left side of the console actuates the parking
brake lock (Figure 3). To engage the parking brake, connect
the pedals with the locking latch, push down on both pedals,
and pull the parking brake latch out. To release the parking
brake, press both pedals until the parking brake latch retracts.
Hazard Light Switch
Press the hazard light switch
lights.
Turn Signal Switch
Press the left side of the turn signal switch
activate the left turn signal and the right side of the switch to
activate the right turn signal. The center position is off.
Key Switch
The key switch (Figure
On/Preheat, and Start.
3
4
5
6
7
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine Speed Switch
The engine speed switch
the engine speed. By momentarily tapping the switch, the
engine speed can be increased or decreased in 100 rpm
increments. By holding the switch down the engine will
automatically move to High or Low idle, depending on which
of the switch is depressed.
16
3) down to tilt the steering wheel
(Figure 3) to activate the hazard
(Figure
4) has three positions: Off,
2
1
Figure 4
5. Hi-Lo speed control
6. Engine speed switch
7. Light switch (optional)
(Figure 4) has two modes to change
3) to
g028453