Philips DVDR3330H/02 Service Manual page 11

4.5 Dismantling of the Basic Engine (Drive D4.3)
1) Remove 4 screws to loosen the Basic Engine assembly
1005+258+902 as shown in Figure 4-10.
Figure 4-10
2) Remove 2 screws to loosen the Bracket Loader 258 and
uncatch the Dust cover assembly 902.
3) Remove 4 screws to loosen the Cover of the Basic
Engine to reach Service position Figure 4-11.
Figure 4-11: Basic Engine Service Position
Mechanical Instructions
4.6
Insulation Sheet
3139 785 31150
Dismantling of the Analog Board
1) Remove the Basic Engine assembly as given in step 4.5.
2) Remove 7 screws on the Rear panel 228 as shown in
Figure 4-12.
Figure 4-12
3) Remove 3 screws and 1 catch mounting the Analog
Board to the Frame assembly 920 as given in Figure 4-13
Figure 4-13
4) Service Position is achieved by placing the Analog Board
in the vertical position as shown in Figure 4-14.
Figure 4-14: Analog Board Service Position
4. EN 11