Figure 20
Figure 21
Figure 22
2. Position the machine and cutting unit on a level surface
and lower the cutting unit. Remove the dipstick/fill plug
from the top of the gear box (Fig. 23) and make sure
that the lubricant is between the marks on the dipstick.
If the lubricant level is low, add SAE 80–90 wt. gear
lube until the level is between the marks.
Figure 23
1. Fill/check plug
Separating the Cutting Unit
from the Traction Unit
1. Position the machine on a level surface, raise the cutting
unit, engage the parking brake, put the traction pedal in
neutral, the PTO lever in the Off position, shut the
engine off, and remove the ignition key.
Caution
The counterbalance spring is in tension when the
deck is in the lowered position.
Always raise the deck before adjusting or
removing the spring.
2. Disconnect the counterbalance from the traction unit,
remove the lock pins from the brackets, separate the
spring tension assemblies from the brackets, and lay
them down on the deck. Loosely secure the lock pins to
the brackets to prevent losing them (Fig. 24).
18
1