Table of Contents
Advertisement
Preparing the Remote Controller
Inserting the Batteries
1
Remove the battery compartment cover by pressing
the tab and lifting up the cover.
2
Insert the two batteries (size AAA/R03).
Be sure to match the + and – ends of the batteries with the
diagram inside the battery compartment.
3
Replace the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this
will vary depending on usage.
Using the Remote Controller
Point the remote controller toward the remote control sensor.
Remote control sensor
30˚
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of
the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put any object such as a book on the remote controller.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
30˚
13
Advertisement
Table of Contents
