Starting The Engine; Driving The Machine - Toro 07383 Operator's Manual

Hide thumbs Also See for 07383:
Table of Contents

Advertisement

2. Ensure that the fluid level is up to the Full line on the
reservoir
(Figure
24).
1. Brake-fluid reservoir
3. If the fluid level is low, clean the area around the cap,
remove the reservoir cap, and fill the reservoir to the
proper level with the specified brake fluid
Note: Do not overfill the reservoir with brake fluid.
Note: You can remove the hood access to the reservoir from
the front of the machine
1. Brake-fluid reservoir
Figure 24
(Figure
(Figure
25).
Figure 25

Starting the Engine

1. Sit on the operator's seat and engage the parking brake.
2. Disengage the PTO and the high-flow hydraulics (if
equipped) and move the throttle lever to the O
position (if equipped).
3. Move the shift lever to the N
press the clutch pedal.
4. Ensure that the hydraulic-lift lever is in the center
position.
5. Keep your foot off the accelerator pedal.
6. Insert the key into the ignition switch and rotate it
clockwise to start the engine.
Note: Release the key when the engine starts.
Important: To prevent overheating of the starter motor,
do not engage starter longer than 15 seconds. After 15
seconds of continuous cranking, wait 60 seconds before
engaging the starter motor again.
24).

Driving the Machine

1. Release the parking brake.
2. Fully press the clutch pedal.
3. Move the gear-shift lever to first gear.
4. Release the clutch pedal smoothly while pressing the
accelerator pedal.
5. When the machine gains enough speed, remove your
foot from the accelerator pedal, fully press the clutch
pedal, move the gear-shift lever to the next gear, and
release the clutch pedal while pressing the accelerator
pedal.
6. Repeat the procedure until the desired speed is attained.
Important: Always stop the machine before
shifting to reverse from a forward gear or to a
forward gear from reverse.
Note: Avoid long periods of engine idling.
Use the chart below to determine the ground speed of
the vehicle at 3,600 rpm.
Range
Gear
1
L
2
L
3
L
1
H
2
H
3
H
R
L
R
H
26
position and
EUTRAL
Speed
Speed
Ratio
(kmh)
(mph)
82.83 : 1
4.7
2.9
54.52 : 1
7.2
4.5
31.56 : 1
12.5
7.7
32.31 : 1
12.2
7.6
21.27 : 1
18.5
11.5
12.31 : 1
31.9
19.8
86.94 : 1
4.5
2.8
33.91 : 1
11.6
7.1
FF

Advertisement

Table of Contents
loading

This manual is also suitable for:

07384h0738407384tc0738607386h07386tc ... Show all

Table of Contents