Checking The Hydraulic Oil Level - Toro 74812 Operator's Manual

Figure 25
1. Oil drain
2. Oil drain plug
6. Remove the oil drain plug
Remove the oil fill cap/dipstick
(Figure 24).
7. Be sure to allow ample time for complete
drainage.
8. Remove the old filter and wipe off the
mounting pad (Figure
9. When the oil has drained completely,
install the oil drain plug. Tighten the plug
to 14 N-m (125 in-lb) torque. Wipe up any
excess oil on the frame
Note:
Dispose of the used oil at a recycling
center.
10. Apply a thin film of clean oil to the rubber
gasket on the new filter.
11. Install the replacement oil filter to the
mounting pad. Turn the oil filter clockwise
until the rubber gasket contacts the pad,
then tighten the filter an additional 1/2 to
3/4 turn (Figure 26).
3. Pan
(Figure 25).
26).
(Figure 25).
1. Oil filter
2. Gasket
12. Slowly pour approximately 80% of the
specified oil into the filler tube
13. Install the oil fill cap/dipstick and push
firmly into place
14. Check the oil level
Checking the Oil Level.
15. Slowly add additional oil to bring it to the
full mark.
16. Install the oil fill cap/dipstick and push
firmly into place
Checking the Hydraulic Oil
Level
Check expansion tank and if necessary add
MOBIL 1 15W-50 synthetic motor oil to the
FULL COLD line.
1. Seat
2. Engine
31
Figure 26
(Figure
(Figure 24).
(Figure 24); refer to
(Figure 24).
Figure 27
3. Expansion Tank
24).