Specifications - Toro 74812 Operator's Manual

Specifications

Engine Specifications:
See Your Engine Owner's Manual
RPM:
Full Speed: 3650 ± 100 (max) RPM
(No Load)
Idle: 1650 (min) RPM
Fuel System:
Capacity: 4.0 gal. (15.1L)
Type of Fuel: Regular unleaded gasoline,
87 octane or higher.
Fuel Filter: replaceable in-line BRIGGS &
STRATTON P/N 695666
Fuel Shut-Off Valve: in-line, 1/4 turn
Electrical System:
Charging System: Flywheel Alternator
Charging Capacity: 16 amps
Battery Type: BCI Group U1
Battery Voltage: 12 Volt
Polarity: Negative Ground
Fuses: 1-25 amp, 1-20 amp, 1-15amp
blade type
Safety Interlock System:
PTO must be disengaged, brake engaged,
and motion control levers out (neutral
lock) to start engine. (It is not necessary
for the operator to be in the seat to start the
engine.)
Operator must be in seat when PTO is
engaged, brake is disengaged, or motion
control levers are moved in or engine will
stop.
Engine will stop if either the left, the right, or
both levers are moved from neutral lock
position while brake is engaged.
Operator Controls
Steering and Motion Control:
Separate levers, on each side of the
console, control speed and direction of
travel of the respective drive wheels.
Steering is controlled by varying the
position of the levers relative to each
other.
Moving motion control levers outward (in
slots) locks the drive system in neutral.
Motion control levers are adjustable to
two heights.
PTO Switch: Engages electric clutch (to
drive belt) which engages mower
blades.
Parking Brake Lever: Engages parking
brake.
Deck Height Adjustment Pin: Sets cutting
height to desired position.
Deck Lift: Foot pedal that raises the deck.
Seat:
Type: Standard seat: high back, foam
padded with spring suspension.
Mounting: Hinged to tilt up for access to
battery and other components. Held in
tilted position with lanyard. Adjustable
fore and aft.
Armrests: Standard: foam padded flip-up
adjustable height armrests.
Seat Safety Switch: Incorporated into the
Safety Interlock System.
Hydrostatic Ground Drive System:
Hydrostatic Drive: Two Hydro Gear ZT2800
Integrated drive systems.
Hydraulic Oil: Use Mobil 1 15W-50 Synthetic
Motor Oil.
Speeds: All units:
0 – 7 mph (11.3 km/hr) forward.
0 – 5 mph (8.0 km/hr) reverse.
Drive wheel releases, located on left and
right sides of engine deck, allow machine to
be moved when the engine is not running
and brake is off.
3