Testing The Safety Interlock System - Toro 74585 Operator's Manual

1
Figure 10
1. KeyChoice switch
DANGER
You could back over a child or bystander while the
mower blades or other attachment is engaged and
cause serious injury or death.
• Do not mow in reverse unless it is absolutely
necessary.
• Do not insert the KeyChoice key unless it is
absolutely necessary.
• Always look backward and down before backing
up the machine.
• Use the KeyChoice switch only if you are
certain that no children or other bystanders will
enter the mowing area.
• Be very observant after deactivating the
interlock because the sound of the engine
may prevent you from noticing that a child or
bystander has entered the work area.
• Always remove both the ignition and KeyChoice
keys and put them in a safe place out of the
reach of children or unauthorized users when
you leave the machine unattended.
1. Engage the blades (PTO).
2. Insert the KeyChoice key into the switch (Figure 10).
3. Turn the KeyChoice key.
Note: A red light on the front console (Figure 11)
turns on, indicating that the interlock is disabled.
1. Operating-in-reverse light
4. Operate the machine in reverse and complete your
5. Disengage the blades (PTO) to activate the
6. Remove the KeyChoice key and put it in a safe place
G017872
Testing the Safety Interlock
System
If the safety interlock switches are disconnected or
damaged, the machine could operate unexpectedly,
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
Test the safety interlock system before you use the
machine each time. If the safety interlock system does
not operate as described below, have an Authorized
Service Dealer repair the safety interlock system
immediately. While sitting in the seat, perform the
following checks:
1. Set the parking brake, shift the blade control (PTO)
2. Shift the blade control (PTO) knob to the Disengage
3. Set the parking brake, shift the blade control (PTO)
4. Shift the blade control (PTO) knob into the
14
1
Figure 11
task.
interlock.
out of the reach of children.
CAUTION
daily and replace any damaged switches before
operating the machine.
knob to the Engage position, and turn the ignition
key to Start: The engine should not crank.
position, release the parking brake, and turn the
ignition key to Start: The engine should not crank.
knob to Disengage, and start the engine. While the
engine is running, release the parking brake and rise
slightly from the seat: The engine should stop.
Disengage position, put the traction control pedal
in the Neutral position, and start the engine. While
the engine is running, shift the blade control (PTO)
knob into the Engage position and put the traction
control pedal in the Reverse position: The engine
should stop.
G017873