Adjusting The Cutting Unit; Installing The Grass Basket - Toro 04054 Operator's Manual

Figure 10
1. Locking clip
3. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is secured
in the groove on the axle shaft.
4. Repeat the procedure on the opposite side of the
machine.
5. Inflate the tires to 12 to 15 psi. (574 to 718 Pa).
6. Carefully lower the machine off the kick stand by
pushing forward slowly, allowing the kickstand to
spring back to its normal position.
5

Adjusting the Cutting Unit

No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
•
Leveling the Rear Drum to the Reel (page 31).
•
Adjusting the Bedknife to the Reel (page 32).
•
Adjusting the Height of Cut (page 32).
•
Adjusting the Grass Shield Height (page 33).
•
Adjusting the Cut-Off Bar (page 34).
Refer to the Cutting Unit Maintenance section in Maintenance
for instructions on performing these procedures.
6

Installing the Grass Basket

Parts needed for this procedure:
1
Procedure
Grasp the basket by the top lip and slide it onto the basket
mounting rods (Figure 11).
G017591
1. Grass basket
Note: Model 04056 only—When cutting in higher
heights-of-cut, the basket may be lowered by removing each
basket mounting rod and installing each on the opposite side
of the machine.
12
Grass basket
Figure 11
2. Basket mounting rod