Checking The Deck Front-To-Rear Pitch - Toro 30250TE Operator's Manual

6. The tire pressure may also be adjusted slightly to make
a 1/4 in. (6 mm) pitch.
5 3
24 in.
(61cm)
5
2
4
1
Figure 45
1. Caster Wheel
2. Carrier Frame
3. 1/4–3/8 in. (6 mm–10 mm)
pitch over 24 in. (61 cm)
length
Checking Carrier Frame Side–to–Side
1. Stop the engine, remove the key and disconnect the
spark plug wire(s) from the spark plug(s).
2. Adjust the tire pressure in all tires to specifications on
page 27.
3. Measure carrier frame height at location "A" (Fig. 46).
4. Measure carrier frame height at location "B" (Fig. 46).
5. If the carrier frame height is not the same move
spacers from top or bottom of caster wheel, to make it
level. The tire pressure may also be adjusted slightly to
make it level.
4
m–5242
4. Height at locations A
and B
5. Caster spacers
33
3
5
2
4 1
Figure 46
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
Checking the Deck
Front-to-Rear Pitch
1. Check the tire pressure on both deck and traction unit.
2. Position one blade front-to-rear (Fig. 47). Measure at
"C" and "D" locations (Fig. 47) from a level surface to
the cutting edge of the blade tips (Fig. 48).
3. The mower blade should be 1/4 in. (6 mm) lower in
front "C" than in the rear "D". Rotate blades and
repeat for other blades. If it is not correct, proceed to
Changing the Deck Front–to–Rear Pitch.
Figure 47
2 5
4
1
m–5231
4. Same height at locations
A and B
5. Caster spacers
m–1078