Lower Control Bar Operation; Stopping The Machine; Transporting Machines - Toro 30250TE Operator's Manual

Mid–size mower proline gear 12.5 hp with 36 in. side discharge mower
Table of Contents

Advertisement

3. Slowly squeeze the lower control bar and handle
together to move rearward (Fig. 15).

Lower Control Bar Operation

This procedure is for driving up a curb. This can be
performed while driving forward or backward.
1. Disengage the mower blades.
Warning
A blade can be bent or damaged when driving up
a curb. Pieces of blade that may be thrown could
seriously injure or kill you or bystanders.
Do not run blades while driving up a curb
forward or backward.
2. Select first gear or reverse to drive machine.
3. Drive machine until drive wheels contact curb
(Fig. 17).
Note: Both drive wheels should contact the curb and
caster wheels straight.
4. At the same time engage lower control bar and lift up
on handle (Fig. 16 and 17).
Note: Lifting up on handle will assist driving the machine
up a curb and not spin the drive wheels.
Figure 16
1. Lower Control Bar
(Engaged)
1
2
m–5190
2. Handle
19
1
Figure 17
1. Lower Control Bar
engaged and mower in
reverse.

Stopping the Machine

To stop the machine, pull back on the upper control bar,
release the blade control bail (PTO), and turn the ignition
key to "OFF" to stop the engine. Also set the parking
brake if you leave the machine unattended; refer to
Setting the Parking Brake, page 16. Remember to remove
the key from the ignition switch.
Caution
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Transporting Machines

Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting
and marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you, your family, pets or bystanders avoid injury.
To transport the machine:
Lock brake and block wheels.
Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
Secure a trailer to towing vehicle with safety chains.
2
m–4185
2. Pull up to assist machine

Advertisement

Table of Contents
loading

Table of Contents