Cleaning And Storage; Troubleshooting - Toro 30250TE Operator's Manual

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, and engine.
3. Check the brake; refer to Brake Service, page 27.
4. Service the air cleaner; refer to Air Cleaner Service,
page 23.
5. Grease the machine; refer to Greasing and Lubrication,
page 26.
6. Change the crankcase oil; refer to Engine Oil Service,
page 24.
7. Check the tire pressure; refer to Tire Pressure, page 27.
8. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank
(1 oz. per gallon or 7.82 ml to one liter).

Troubleshooting

PROBLEM
Engine will not start, starts hard, or g ,
fails to keep running.
POSSIBLE CAUSES
, 1. Fuel tank is empty.
2. Choke is not ON.
3. Air cleaner is dirty.
4. Spark plug wire is loose or
disconnected.
5. Spark plug is pitted, fouled, or
gap is incorrect.
6. Dirt in fuel filter.
7. Dirt, water, or stale fuel is in
fuel system.
41
A. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the fuel tank;
refer to Fuel Tank, page 29, or operate engine until
it stops.
C. Restart engine and run until it stops. Repeat, on
"CHOKE" until engine will not restart.
D. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned gasoline over 90
days.
9. Remove the spark plug(s) and check its condition;
refer to Spark Plug Service, page 25. With the spark
plug(s) removed from the engine, pour two
tablespoons of engine oil into the spark plug hole.
Now use the starter to crank the engine and distribute
the oil inside the cylinder. Install the spark plug(s). Do
not install the wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place. Cover the machine to
protect it and keep it clean.
CORRECTIVE ACTION
1. Fill fuel tank with gasoline.
2. Move throttle lever to choke
position.
3. Clean or replace air cleaner
element.
4. Install wire on spark plug.
5. Install new, correctly gapped
spark plug.
6. Replace fuel filter.
7. Contact Authorized Service
Dealer.