Operating Your Radio - Fm Auto-Tune - Sangean DDR-36 Operating Instruction

Operating your radio - FM auto-tune

. Fully extend the telescopic aerial located on the rear of your radio.
. Press the Standby button to switch on your radio.
. Press and release the Mode button until the FM band is selected.
4. Press and release the Auto tune button to cause your radio to search from low frequency to
high frequency and to stop automatically when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show the frequency of the signal
found. If the signal is strong enough and there is RDS data present then the radio may display
the station name.
6. To find other stations press the Auto tune button as before. When the end of the waveband is
reached, your radio will recommence tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Standby button.
Note:
If you find that FM reception is poor, try repositioning the aerial. If you find that an FM broadcast
has a lot of background hiss, this may often be reduced by setting the radio into Mono reception
mode for the current FM station. Please refer to the later section "Stereo / Mono setting - FM".
FM Mode
87.50MHz
Scanning...
GB
4