Related Manuals for Sangean DT-200VX
Summary of Contents for Sangean DT-200VX
- Page 1 381QG01-A Operating instruction FM STEREO / AM / TV 19 MEMORY PRESETS PLL SYNTHESIZED RECEIVER DT-200VX...
-
Page 2: Limited Warranty
Limited Warranty Sangean America, Inc. warrants this product to be free from defects in material and workmanship under normal use and conditions for a period of 90 (Ninety) days from the date of original purchase on parts and labor. Should service be necessary for any reason due to manufacturing defect or malfunction during the warranty period Sangean America, Inc. - Page 3 Any applicable implied warranties, including the warranty of merchantability, are limited in duration to a period of 90 (Ninety) days from the date of original purchase. No other warranties, whether expressed or implied shall apply to this product thereafter. Sangean America, Inc. is not liable for any loss or damage, direct or consequential arising out of the use of, or inability to use this product.
- Page 5 Headphone/Antenna Jack Note: To improve reception during speaker use, leave headphones or external antenna device plugged in through earphone jack. Volume Control You can rotate the volume control wheel located on the top of the unit clockwise to increase volume, counter-clockwise to decrease volume. Deep Bass Boost The deep bass boost selector switch located on the top back of the unit provides better bass...
- Page 7 Speaker/Headphone Selector On the top left side of the radio you will find the output selector switch. With this selector switch you can choose to use the built-in speaker, or headphones. To use speaker: Set selector switch to SP. Selection To use Headphones: •...
- Page 9 Removal: It can be removed by gently pushing on the center tab of the clip where indicated, and sliding the clip downward towards the bottom of the radio. Replacement: You can easily connect the belt clip by inserting the top of the clip into the designated receiver slots and gently pushing the clip in an upwards motion towards the top of the radio.
-
Page 10: Battery Installation
Tuning the Radio Seek Tuning • Turn radio on using the On/Off button located on the top of the radio. • Select desired band by pressing the “Band” selector on the front of the unit. - Page 11 Manual Step Tuning • Turn radio on using the On/Off button located on the top of the radio. • Select desired band by pressing the “Band” selector on the front of the unit. • Press the desired tuning button (Up/Down) repeatedly until desired frequency is found.
-
Page 12: Setting The Clock
To set the clock: • Turn unit off by depressing the power button located on the top of the radio. • Press and hold MEMO or CLOCK button until the hour setting begins blinking and the colon is no longer blinking. -
Page 13: Specifications
SPECIFICATIONS Band Frequency: AM 520 - 1710 kHz FM 87.5 - 108 MHz TV ch 2 - 13 (VHF) Earphone Jack: 3.5mm mini-plug 16 ohm impedance (stereo) Output Power: 60mW (10% THD) via built-in speaker 16 ohm impedance (stereo) Speaker: 1 inch diameter, 4 ohms impedance External Power: Speaker...