Changing The Light Bulbs - Kenmore 106.4022 series Use & Care Manual

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to
replace the bulb with one of the same size and shape.
The dispenser light requires a heavy duty 10-watt bulb.
All other lights require a 40-watt appliance bulb.
1. Unplug refrigerator or disconnect power.
2. Remove light shield when applicable as shown.
NOTE: To clean the light shield, wash it with warm water and
liquid detergent. Rinse and dry the shield well.
3. Remove light bulb and replace with one of the same size, shape
and wattage.
4. Replace light shield when applicable as shown.
5. Plug in refrigerator or reconnect power.
Dispenser Light (on some models)
Reach through the dispenser area to remove and replace
light bulb.
A. Dispenser light
NOTE: On some models, the dispenser lights are LEDs that cannot
be changed.
Refrigerator Control Panel Light (on some models)
Reach behind the refrigerator control panel to remove and replace
light bulb.
Crisper Lights
If necessary, remove the top crisper drawer for easier access to
the crisper light shield. Remove the light shield by squeezing the
top and bottom in toward the center and pulling the bottom
tabs out of the refrigerator liner, then sliding the top tabs down
and out.
Replace the light shield by sliding the top tabs up into the
slotted holes in the refrigerator liner, then snapping the bottom
tabs into place. If necessary, replace the top crisper drawer.
Upper Freezer Light (on some models)
Style 1
Remove light shield by grasping the top center of the shield
and pulling forward while turning it slightly to one side. If
necessary, remove top crisper drawer to gain access to the
crisper light shield.
16

Changing the Light Bulbs

Style 2
A
Style 1 – Beneath Ice Bin
Style 2 – Behind Freezer Basket
Replace the light shield by inserting the tabs on one end into
the slotted holes in the refrigerator or freezer liner. Then, bend
the shield at the center to insert the tabs on the other end.
Remove the light shield by squeezing the sides of the light
shield in toward the center while pulling the shield forward as
shown.
Replace the light shield by fitting the tabs into the slotted holes
in the freezer liner. Push in the shield until it snaps into place.
Lower Freezer Light (on some models)
Remove the light shield by grasping the sides and squeezing in
toward the center. Once the side hooks of shield are free from
the freezer lining, pull down the shield.
Replace the light shield by squeezing the sides toward the
center and inserting the side hooks into the slotted holes. Once
the side hooks are in place, snap the front tab into the slotted
hole.
Depending on your model, remove the top freezer basket or
top freezer basket shelf. Remove light shield by removing the
Phillips screw on the top of the shield. Gently rotate the shield
until the left tab can be pulled from the freezer wall.
Replace the light shield by inserting the left tab into the freezer
wall. Align top tab with screw hole and replace screw.