Changing The Light Bulbs; Power Interruptions; Vacation And Moving Care - Kenmore 106.5022 series Use & Care Manual

Changing the Light Bulbs

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to
replace the bulb with one of the same size and shape. The
dispenser light requires a heavy duty 10-watt bulb. All other lights
require a 40-watt appliance bulb. Replacement bulbs are
available from your dealer.
1. Unplug refrigerator or disconnect power.
2. Remove light shield when applicable as shown.
NOTE: To clean the light shield, wash it with warm water and
liquid detergent. Rinse and dry the shield well.
3. Remove light bulb and replace with one of the same size, shape
and wattage.
4. Replace light shield when applicable as shown.
5. Plug in refrigerator or reconnect power.
Dispenser Light (on some models)
Reach through the dispenser area to remove and replace
light bulb.
A. Dispenser light
Refrigerator Control Panel Light
Reach behind the refrigerator control panel to remove and replace
light bulb.
Crisper Lights
If necessary, remove the top crisper drawer for easier access to
the crisper light shield. Remove the light shield by squeezing the
top and bottom in toward the center and pulling the bottom
tabs out of the refrigerator liner, then sliding the top tabs down
and out.
Replace the light shield by sliding the top tabs up into the
slotted holes in the refrigerator liner, then snapping the bottom
tabs into place. If necessary, replace the top crisper drawer.
Upper Freezer Light (on some models)
Remove light shield by grasping the top center of the shield
and pulling forward while turning it slightly to one side. If
necessary, remove top crisper drawer to gain access to the
crisper light shield.
20
A
Replace the light shield by inserting the tabs on one end into
the slotted holes in the refrigerator or freezer liner. Then, gently
bend the shield at the center to insert the tabs on the other end.
Lower Freezer Light (on some models)
Remove the light shield by grasping the sides and squeezing in
toward the center. Once the side hooks of shield are free from
the freezer lining, pull down the shield.
Replace the light shield by squeezing the sides toward the
center and inserting the side hooks into the slotted holes. Once
the side hooks are in place, snap the front tab into the slotted
hole.

Power Interruptions

If the power will be out for 24 hours or less, keep the door or doors
closed (depending on your model) to help food stay cold and
frozen.
If the power will be out for more than 24 hours, do one of the
following:
Remove all frozen food and store it in a frozen food locker.
Place 2 lbs (907 g) of dry ice in the freezer for every cubic foot
(28 L) of freezer space. This will keep the food frozen for 2 to
4 days.
If neither a food locker nor dry ice is available, consume or can
perishable food at once.
REMEMBER: A full freezer stays cold longer than a partially filled
one. A freezer full of meat stays cold longer than a freezer full of
baked goods. If you see that food contains ice crystals, it may be
refrozen, although the quality and flavor may be affected. If the
condition of the food is poor, dispose of it.

Vacation and Moving Care

Vacations
If You Choose to Leave the Refrigerator On While You're
Away:
1. Use up any perishables and freeze other items.
2. If your refrigerator has an automatic ice maker:
Raise wire shutoff arm to OFF (up) position or move the
switch to the OFF (right) setting.
Shut off water supply to the ice maker.
3. Empty the ice bin.