Connecting The Power/Turning On The Dvd Receiver - Onkyo DR-L50 Instruction Manual

Connecting the Power/
Turning on the DVD Receiver
Before connecting
• Make sure that all the connections from pages 18 to 25 are
complete (the connection to the TV is required).
• Turning on the DVD Receiver may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. If this happens, use a wall outlet on a different
circuit.
1
Connect the power cord to the AC
INLET of the DVD Receiver.
2
Connect the power cord to a wall
outlet.
The DVD Receiver enters the standby
mode and the STANDBY indicator lights
up.
3
Press STANDBY/ON on the DVD
Receiver or ON on the remote
Unit
controller to turn on the DVD
Receiver.
The light and display on the DVD
Receiver's front panel light. At the same
time, the STANDBY indicator goes off and
the ON indicator lights up.
Remote
Controller
ON
• To put the DVD Receiver in the standby
• While in the STANDBY mode, the DVD
• Setting the STANDBY button on the
26 26
AC INLET
AC INLET
to wall outlet
ON indicator
STANDBY indicator
mode, press STANDBY/ON on the DVD
Receiver, or STANDBY on the remote
controller. Be sure to set the volume to
minimum before putting the DVD
Receiver in the standby mode for the
next use to avoid sudden loud sound
reproduction.
Receiver can receive signals from the
remote controller.
remote controller to standby does not
shut off the power completely.
STANDBY/ON
ON indicator
STANDBY indicator
PROGRESSIVE SCAN
THEATER DIMENSIONAL
IPM
I Setting the Clock Display
To display the clock while in Standby mode, hold down the
STANDBY/ON button for at least 2 seconds when switching from
On to Standby mode.
Note
Displaying the clock in Standby mode consumes the same amount of
power as in the On mode.
Display