Cleaning The Cooling System; Checking The Tire Pressure; Draining The Fuel Tank; Replacing The Fuel Filter - Toro 71246 Operator's Manual

Installing the Spark Plug
1. Install the spark plug and metal washer.
Note: Make sure that the air gap is set correctly.
2. Tighten the spark plug to 15 ft-lb (20 N⋅m).
3. Connect the wire to the spark plug (Fig. 25).
4. Close the hood.

Cleaning the Cooling System

Use a dry brush to clean grass and accumulated debris from
the engine daily.
Important To prevent contaminating the fuel system,
do not use water to clean the engine.

Checking the Tire Pressure

Maintain the air pressure in the front and rear tires at 20 psi
(138 kPa). Check the pressure at the valve stem (Fig. 27)
after every 25 operating hours or yearly, whichever occurs
first. Check the tires when they are cold to get the most
accurate pressure reading.
Figure 27
1. Valve stem

Draining the Fuel Tank

Danger
In certain conditions, gasoline is extremely
flammable and highly explosive. A fire or
explosion from gasoline can burn you and others
and can damage property.
• Drain gasoline from the fuel tank when the
engine is cold. Do this outdoors in an open area.
Wipe up any gasoline that spills.
• Never smoke when draining gasoline, and stay
away from an open flame or where a spark may
ignite the gasoline fumes.
1. Park the tractor so that the left front side is slightly
lower than the right side to ensure that the fuel tank
drains completely.
2. Disengage the PTO and set the parking brake.
3. Stop the engine, remove the key, and wait for all
4. Open the hood and locate the fuel filter (Fig. 28).
5. Squeeze the ends of the hose clamp together and slide it
6. Pull the fuel line off of the fuel filter (Fig. 28) and allow
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty.
7. Install the fuel line onto the fuel filter.
8. Slide the hose clamp close to the fuel filter to secure
1
1. Hose clamp
2. Fuel line
m-1872

Replacing the Fuel Filter

Replace the fuel filter after every 100 operating hours or
yearly, whichever occurs first. The best time to replace the
fuel filter (Fig. 28) is when the fuel tank is empty. Never
install a dirty fuel filter after it has been removed from the
fuel line.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
3. Open the hood.
4. Squeeze the ends of the hose clamps together and slide
5. Remove the fuel filter from the fuel lines.
6. Install a new fuel filter and move the hose clamps close
7. Close the hood.
27
moving parts to stop before leaving the operating
position.
up the fuel line toward the fuel tank (Fig. 28).
gasoline to drain into a fuel container or a drain pan.
both the fuel line and the fuel filter.
Figure 28
moving parts to stop before leaving the operating
position.
them away from the fuel filter (Fig. 28).
to the fuel filter.
2
1
3
3. Filter