Storage; Cleaning And Storage - Toro 30074 Operator's Manual

Commercial walk-behind mower
Hide thumbs Also See for 30074:
Table of Contents

Advertisement

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the shift lever plate, and engine.
3. Check the brake; refer to Servicing the Brake in
Maintenance (page
4. Service the air cleaner; refer to Servicing the Air
Cleaner in
Engine Maintenance (page
5. Grease the machine; refer to Greasing and Lubrication
in
Lubrication (page
6. Change the engine oil; refer to Servicing the Engine in
Engine Maintenance (page
7. Check the tire pressure; refer to Checking the Tire
Pressure in
Drive System Maintenance (page
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank in
Maintenance (page
it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug in
(page
25). With the spark plug(s) removed from the
engine, pour two tablespoons of engine oil into the
spark plug hole. Now use the starter to crank the
engine and distribute the oil inside the cylinder. Install
the spark plug(s). Do not install the wire on the spark
plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
34).
25).
24).
25).
Fuel System
29), or operate engine until
Engine Maintenance
12. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
Brake
30).
46

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

300783907439078

Table of Contents