Adjusting The Handle Height - Toro 30074 Operator's Manual

Figure 15
48 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
Figure 16
48 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
4. Anti-scalp rollers
5. Nut
4. Bushing
5. Anti-scalp rollers
6. Nut
36 inch Mower Deck
1. Mower deck
2. Bolt
3. Spacer
Note: In certain mowing conditions and terrain, a
mismatch of cutting height may be seen. Adjusting
the outside anti-scalp rollers to the minimum setting
of 10 mm (3/8 inch) will help prevent the mower
deck cutting too low on the outside and minimize the
mismatch.

Adjusting the Handle Height

The handle position can be adjusted to match the operator's
height preference.
1. Remove the hairpin cotter, washer, and clevis pin
securing the control rod fitting to the idler bracket
(Figure 18).
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
19
Figure 17
4. Anti-scalp rollers
5. Nut
Figure 18
4. Washer
5. Hairpin cotter
6. Rod fitting