The Safety-Interlock System; Driving Forward Or Backward - Toro 30074 Operator's Manual

1. Upper control bar
2. Blade control bail
Disengaging the Mower Blades (PTO)
Release the blade control bail to disengage the blades
9).

The Safety-Interlock System

CAUTION
If the safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety-Interlock
System
The safety-interlock system is designed to prevent the mower
blades from rotating unless:
•
The control bail is pressed against the upper control bar.
•
The power-takeoff switch (PTO) is pulled to the On
position.
The safety-interlock system is designed to stop the mower
blades if you release the blade control bail.
Figure 9
3. Power take off switch
(PTO)
Testing the Safety-Interlock System
Service Interval: Before each use or daily
Test the safety interlock system before you use the machine
each time.
Note: If the safety system does not operate as described
below, have an Authorized Service Dealer repair the safety
system immediately.
1. Set the parking brake and start the engine; refer to
Starting and Stopping the Engine (page
2. Squeeze the blade-control bail against upper control
bar.
Note: The blades should not rotate.
3. Then continue holding the blade-control bail and pull
up on the blade control switch and release. The clutch
should engage and the mower blades begin rotating.
4. Release the blade-control bail.
Note: The blades should stop rotating.
5. With the engine running, pull up the power take off
switch (PTO) and release without holding the blade
control bail. The blades should not rotate.
(Figure

Driving Forward or Backward

The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the Fast position for best mowing performance.
Driving Forward
1. To go forward, move the shift lever to a forward gear
(Figure
2. Release the parking brake; refer to
Parking Brake (page
3. Slowly press on the upper control bar to move forward
(Figure
To go straight, apply equal pressure to both ends of the
upper control bar
To turn, release pressure on the upper control bar side
in the direction you want to turn
15
10).
14).
10).
(Figure 10).
(Figure
14).
Releasing the
10).