Toro 79110 Operator's Manual page 6

2
Installing the Mower
Parts needed for this procedure:
2 Bolt, 5/16 x 2-1/2 in.
2 Locknut, 5/16 in.
4 Hairpin cotter
2 Thin washer
2 Thick washer
Procedure
DANGER
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in place,
you and others are exposed to blade contact and
thrown debris. Contact with the rotating mower
blade(s) and thrown debris will cause injury or
death.
• Never remove the grass deflector from the mower
because the grass deflector routes material down
toward the turf. If the grass deflector is ever
damaged, replace it immediately.
• Never put your hands or feet under the mower.
• Never try to clear the discharge area or mower
blades unless you move the power take off
(PTO) to Off and rotate the ignition key to Off.
Also remove the key and disconnect the wire
from the spark plug(s).
1. Park the machine on a level surface, disengage the
blade control (PTO), set the parking brake, and turn
the ignition key to Off to stop the engine. Remove
the key.
2. Turn the front wheels fully to the left. Slide the
mower under the chassis from the right side.
3. Install the mower belt onto the electric clutch pulley
(Figure 6).
1. Mower belt
4. Install the mower pivot mount brackets onto the
front axle with the bolts and locknuts (Figure 7).
1. Pivot mount bracket
2. Bolt, 5/16 x 2-1/2 in.
5. Move the height-of-cut lever into the D notch.
6. Remove the lift assist spring between the mower
right side lift bracket and the retaining bolt (Figure 8).
6
Figure 6
2. Electric clutch pulley
Figure 7
3. Locknut