Preparing The Mower; Installing The Mower; Figure - Toro 79110 Operator's Manual

1

Preparing the Mower

Parts needed for this procedure:
1 Grass deflector
2 Spring
2 Bolt, 3/8 x 3-1/2 in.
2 Locknut, 3/8 in.
2 Gage wheel
2 Pin
2 Hairpin cotter
1 Mower mounting plate
2 Shoulder bolt
2 Locknut
Procedure
1. Place the springs into the brackets on the mower
with the hooked ends over the raised back (Figure 3).
1. Bracket
2. Spring hook end
3. Space for spring
2. Align the grass deflector with the holes in the
brackets and the straight ends of the spring in the
space under the hinge and above the deflector

(Figure 3).

3. Secure the deflector to the bracket with bolts through
the grass deflector, springs, and brackets. Secure
them with the locknuts (Figure 3).
4. Lift the grass deflector and check that it is spring
loaded and pivots freely to the full down position.
Figure 3
4. Grass deflector
5. Bolt
6. Locknut
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
5. Deflect the anti-rattle spring, slide the adjusting
plate of the gage wheel into the mower gage wheel
bracket, and secure it with the pin and hairpin cotter
(Figure 4).
1. Anti-rattle spring
2. Plate
3. Bracket
Note: After installing the mower onto the tractor,
set the height-of-cut and adjust the gage wheels;
refer to Setting the Height-of-Cut (page 12).
6. Repeat the adjustment on the other gage wheels.
7. Position the mounting plate, with the tabs up,
between the brackets on the front of the mower
(Figure 5).
1. Tab up
2. Mower bracket
8. Insert the shoulder bolts through the mounting plate
into the mower brackets. Secure them with locknuts
(Figure 5).
5
Figure 4
4. Pin
5. Hairpin cotter
Figure 5
3. Shoulder bolt
4. Locknut