Table of Contents
Advertisement
Note: A fuel stabilizer/conditioner is most effective
when mixed with fresh gasoline. To minimize the
chance of varnish deposits in the fuel system, use fuel
stabilizer at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around each fuel tank cap and remove the cap.
3. Add unleaded regular gasoline to both fuel tanks,
until the level is 1/4 to 1/2 inch (6 mm to 13 mm)
below the bottom of the filler neck.
This space in the tank allows gasoline to expand.
Do not fill the fuel tanks completely full.
4. Install fuel tank caps securely.
5. Wipe up any gasoline that may have spilled.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
Oil Level in Engine Maintenance (page 24)
Note: Determine the left and right sides of the
machine from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals in
the safety section. Knowing this information could
help you or any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
CAUTION
This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
1. Warning—wear hearing protection.
Using the Parking Brake
Stop on level ground, disengage drives, engage parking
brake, shut off engine and remove key. Always set the
Figure 6
parking brake when you stop the machine or leave it
unattended.
Setting the Parking Brake
1. Pull the upper control bar (Figure 7) rearward and
hold it in this position.
2. Lift the parking brake lock (Figure 7) up and
gradually release the upper control bar. The brake
lock should stay in the set (locked) position.
1. Upper control bar
2. Parking brake lever-set
position
Releasing the Parking Brake
1. Pull rearward on the upper control bar. Lower the
parking brake lock to the released position.
2. Gradually release the upper control bar.
Starting and Stopping the
Engine
Starting the Engine
1. Make sure spark plug wire(s) are installed on spark
plug(s) and fuel valve is open.
2. Move the shift lever to neutral, set the parking brake
and turn ignition key to run.
3. Move the throttle control to fast and move the
choke lever to the on position before starting a cold
engine.
Note: A warm or hot engine usually does not
require any choking. To start a warm engine, move
throttle control to the fast position.
4. Grasp recoil starter handle firmly and pull out
until positive engagement results; then pull handle
vigorously to start engine and allow rope to recoil
slowly.
13
Figure 7
3. Fixed bar
Advertisement
Table of Contents
