Adjusting The Flow Baffle - Toro 74268 Operator's Manual

4
2
1
Figure 18
1. Anti–scalp roller
2. Spacer
3. Bushing
3
1 2
Figure 19
1. Anti–scalp roller
2. Bushing
3 5
m–6821
4. Flange Nut
5. Bolt
4
m–6845
3. Flange Nut
4. Bolt
24
5
m–6844
Figure 20
1. Anti–scalp roller
2. Spacer
3. Bushing

Adjusting the Flow Baffle

The mower discharge flow can be adjusted for different
types of mowing conditions. Position the cam locks and
baffle to give the best quality of cut.
1. To adjust the cam locks, swing the lever up to loosen
the cam lock (Fig. 21).
2. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
3. Swing the lever back over to tighten the baffle and
cam locks (Fig. 21).
4. If the cams do not lock the baffle into place or it is too
tight, loosen the lever and then rotate the cam lock.
Adjust the cam lock until the desired locking pressure
is achieved (Fig. 21).
1
4
Figure 21
1. Cam lock
2. Lever
1
2
1
3
4. Flange Nut
5. Bolt
1
2
3
m–6823
3. Rotate cam to increase or
decrease locking pressure
4. Slot