Unlatching The Seat; Pushing The Machine By Hand - Toro 74268 Operator's Manual

1
Figure 25
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where it is
most comfortable.
1. To adjust, turn the knob, under the rightside arm rest,
in either direction to provide the best comfort
(Fig. 26).
2
1
Figure 26
1. Back rest knob
2
m–6861
2. Seat position adjustment
m–6876
2. Rightside arm rest
26

Unlatching the Seat

Push the seat latch downward to unlatch the seat. This will
allow access to the machine under the seat.
3
2
1
Figure 27
1. Seat latch
2. Right side of machine

Pushing the Machine by Hand

Important Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to Off. Move the levers to the neutral
locked position and apply the parking brake.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn (Fig. 28).
Important
Do not rotate the by-pass valves more than
1 turn. This prevents the valves from coming out of the
body and causing fluid to run out.
3. Disengage the parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to operate the
machine (Fig. 28).
Note: Do not over tighten the by–pass valves.
m–7505
3. Seat