Toro 74268 Operator's Manual page 41

1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the belt covers.
4. Grease the three spindle bearings under the pulleys
until grease comes out the lower seals (Fig. 51).
5. Grease the idler arm on the mower deck (Fig. 51).
6. Grease the fittings on the push arms (Fig. 51).
m–7420
Figure 51
7. Grease the cooling fan belt idler arm (Fig. 52).
8. Grease the drive belt idler arms (Fig. 52).
m–7416
Figure 52
1. Left adjustable pulley
9. Grease the pump belt idler arm.
m–7512
Figure 53
Where to Add Light Oil or Spray
Lubrication
Lubricate the machine in the following areas with spray
type lubricant or light oil. Lubricate every 160 hours.
Seat switch actuator
Brake handle pivot
Brake rod bushings
Motion control bronze bushings
41
2. Back of the machine