Table of Contents
Advertisement
The system automatically detects the total amount of onboard memory during the
POST and sets the memory parameters accordingly. If you install additional
memory, the system automatically adjusts the Total Memory parameter to
display the new memory size (refer to section 4.2.7). You must enter CMOS
Setup and exit.
displayed. When changing your system's memory configuration, be sure to run
the ECU to add in the changes.
The CPU includes a math coprocessor so this parameter shows Installed by
default.
The video display is the monitor on which the operating system prompt appears
when you boot the system. The system automatically detects the video mode of
your primary display and sets the configuration value accordingly. Values for
this parameter are:
[Monochrome]
[CGA 40 columns x 25 rows]
[CGA 80 columns x 25 rows]
[VGA/EGA]
A message that the memory configuration has changed is
Advertisement
Table of Contents
