Light Bulb Replacement - Suzuki GSX-R1000/A Owner's Manual

 WARNING
Failure to adjust the drive chain
and failure to torque bolts and
nuts properly could lead to an
accident.
• After installing the rear wheel,
adjust the drive chain as
described in the DRIVE CHAIN
ADJUSTMENT section.
• Torque bolts and nuts to the
proper specifications. If you are
not sure of the proper proce-
dure, have your authorized
Suzuki dealer or a qualified
mechanic do this.
Rear axle nut tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
 WARNING
Failure to extend brake pads after
installing the wheel can cause
poor braking performance and
may result in an accident.
Before riding, "pump" the brake
pedal repeatedly until brake pads
are pressed against the brake
disks and proper pedal stroke and
firm feel are restored. Also check
that the wheel rotates freely.

LIGHT BULB REPLACEMENT

The wattage rating of each bulb is
shown on the table below. When
replacing a burned out bulb, always
use the exact same wattage rating.
Using other than the specified rating
can result in overloading the electrical
system or premature failure of a bulb.
NOTICE
Failure to use a light bulb with the
correct wattage rating can over-
load the electrical system of your
motorcycle or cause the bulb to
burn out sooner.
Use only the light bulbs shown in
the chart as replacement bulbs.
Headlight
Turn signal light
Position light
License plate light
6-46
12V 55W (H11)
... Low beam
12V 65W (H9)
... High beam
12V 21W × 4
12V 5W × 2
12V 5W