Control Rod Adjustment - Toro 30339 Operator's Manual

Mid–size mower proline hydro 15 hp with 52 in. side discharge mower

Hide thumbs

Table Of Contents

Table of Contents

Figure 39

1. Hydro control linkage

2. Front nut

Note: If inconsistent neutral occurs, check to be sure both

springs are properly tightened on the speed control lever

under the console, especially the rear pivot spring. Repeat

above adjustments if necessary (Fig. 40).

Figure 40

1. Speed control lever

2. Rear pivot spring

Right Side Linkage Adjustment

1. Place the speed control lever in the neutral position.

2. Place the right drive lever in the full forward position.

3. Hold OPC levers down.

Note: The OPC levers must be held down whenever the

speed control lever is out of the neutral position or the

engine will kill.

4. Adjust the right side linkage by turning the quick track

knob counterclockwise until the tire begins to rotate

forward (Fig. 41).

m–5394

3. Rear adjusting nut

m–5396

3. spring

5. Turn the knob clockwise 1/4 of a turn at a time. Then

move the speed control forward and back to neutral.

Repeat this until right wheel stops rotating forward

(Fig. 41).

6. The spring that keeps tension on the knob should

normally not need adjustment. However if adjustment

is needed, adjust the length of spring to 1 in. (26 mm)

between the washers (Fig. 41).

7. Adjust spring length by turning nut at front of spring

(Fig. 41).

Figure 41

1. Hydro control linkage

2. Quick track knob