Set Up; Loose Parts; Installing Fuel Tank And Fuel Line - Toro 30339 Operator's Manual

Set Up

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Fuel tank
Bolt 5/16 x 7/8 in. (22 mm)
Lock washer 5/16 in.
Washer 5/16 in.
Stud
Spring
Hose clamp
Upper handle
Flanged bolt 3/8 x 1 in. (26 mm)
Flange nut 3/8 in.
Rod fitting
E–ring
Clevis pin
Hairpin cotter
Hairpin cotter
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card
Installing Fuel Tank and Fuel
Line
1. Align fuel tank to top of rear frame and secure fuel
tank right side with 2 bolts (5/16 x 7/8 in. (22 mm)), 2
lock washers (5/16 in.) and 2 washers (5/16) (Fig. 2).
2. Secure fuel tank left side to frame with 2 studs (5/16
x 7/8 in. (22 mm)), 2 washers (5/16 in.), 2 springs and
2 locknuts (5/16 in.) (Fig. 2).
Note: Tighten left side until it is completely tight and then
unscrew locknut one full turn. This will allow the spring
to work.
QTY.
1
2
2
4 Install fuel tank and fuel line
2
2
1
1
4
Install upper handle to frame
4
2
2
Install control rods
2
2
2 Install hairpin cotter pins
1 Read before operating machine
1
1
1 Fill out and return to Toro
14
USE