Operating The Traction Drive; Using The Wheel Clutch Levers - Toro 38637C Operator's Manual

Figure 31
5. Pull the recoil starter 3 or 4 times. This helps prevent
the recoil starter from freezing up.

Operating the Traction Drive

If the traction drive is not properly adjusted,
the snowthrower may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to Checking the
Traction Drive Operation in Setup for more
information.
Important: If the snowthrower moves when the
traction lever is in the released position, check the
traction cable (refer to Checking and Adjusting
the Traction Cable) or take the snowthrower to an
Authorized Service Dealer for service.
Important: To operate the traction drive, you
must operate the snowthrower with the self-propel
feature engaged. Refer to Freewheeling or Using
the Self-propel Drive.
1. To engage the traction drive, squeeze the left hand
(traction) lever to the handgrip (Figure 32).
2. To stop the traction drive, release the traction lever.

Using the Wheel Clutch Levers

The wheel clutch levers allow you to momentarily
disengage the drive to one or both wheels with the
traction drive lever still engaged. This enables you to
turn and maneuver the snowthrower easily.
Note: Holding down the traction lever against the
handle engages the traction drive to both wheels.
To turn the snowthrower to the right, lift up on the
right wheel clutch lever and squeeze it toward the handle
(Figure 33).
Note: This disengages the drive to the right wheel while
the left wheel continues driving, and the snowthrower
turns to the right.
Note: Similarly, squeezing the left wheel clutch lever
turns the snowthrower to the left.
When you complete the turn, release the wheel clutch
lever, and the drive re-engages both wheels (Figure 34).
16
Figure 32
Figure 33
Figure 34