Stopping The Engine - Toro 38637C Operator's Manual

6. Move the throttle to the Fast position (Figure 28).
7. Start the snowthrower pulling the recoil starter or
pressing the electric-starter button (Figure 29).
1. Electric-starter button
2. Electric starter plug-in
Note: To use the electric starter, connect a power
cord to the electric starter plug-in first and then to
a power outlet.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds
Figure 27
Figure 28
Figure 29
3. Recoil starter
maximum, then wait one minute before trying to
start it again). If the engine still does not start,
take the snowthrower to an Authorized Service
Dealer for service.
8. Disconnect the power cord from the power outlet
first and then from the snowthrower (electric start
only).
9. Allow the engine to warm up for several minutes,
move the choke toward the Run position. Wait
for the engine to run smoothly before each choke
adjustment.
If you leave the snowthrower plugged into a
power outlet, someone can inadvertently start
the snowthrower and injure people or damage
property.
Unplug the power cord whenever you are not
starting the snowthrower.

Stopping the Engine

1. Move the throttle to the Slow position, and then to
the Stop position (Figure 30).
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key.
4. Close the fuel shutoff valve by rotating it clockwise
(Figure 31).
15
Figure 30