3. Disassembly and Reassembly
3-5 Replacement of Fuse
Parts
Fuse
3-6 Replacement of Drive Motor
Parts
Drive
Motor
Explaination Photo
Fuse
Fuse
Explaination Photo
The fuse is located on the noise filter.
1.
Disconnect power and remove grilleand
Assembly Control Box .
. Replace the fuse .
3. When 20A fuse blows out by the operation
of interlock monitor switch failure, replace
the primary interlock switch, secondary
interlock switch, door sensing switch,
interlock monitor switch and power relay .
4. When the above four switches operate
properly, check if any other part such as the
control circuit board, blower motor or high
voltage transformer is defective .
1.
Disconnect power and remove Base
bottom screws(5) .
. Remove Base bottom and disconnect the
turntable motor drive .
3. Remove turntable motor screws(1) and pull
the turntable motor out .
4. When replacing the drive motor, be sure to
remount it in the correct position with the
coupler .
5. Connect all the leads to the drive motor .
17
Explaination
Explaination