Table of Contents
Advertisement
3. Disassembly and Reassembly
3-4 Replacement of Fuse and H.V.Fuse
Parts
Explaination Photo
Fuse,
H.V Fuse
1.6A FUSE
10A FUSE
3-5 Replacement of Drive Motor & Ass'y Stirrier
Parts
Explaination Photo
Assy
Stirrer
To remove Ass'y Stirrer Cover: Hold
side stoppers of ceiling cover with both
hands and pull them in and down.
Drive
Motor
Assy Stirrer Cover
1. Disconnect the oven from the power source.
2. Remove defective fuse from Noise lter.
3. When replacing the fuse, besure to use an exact
4. When the above three switches operate properly,
H.V.FUSE
1. Remove a screw securing the drive motor.
2. Open the door.
3. Hold side stoppers of ceiling cover (Ass'y Stirrer
4. Take the ceiling cover out of the oven cavity.
5. Remove plastic clips securing the Ass'y Stirrer.
Screws
Drive Motor
Assy Stirrer
Plastic Clips
9
Explaination
replacement part. If new fuse blows out again after
replacement, check the primary interlock switch,door
sensing switch and interlock monitor switch.
check if any other part such as the control circuit
board, fan motor or high voltage trans former is
defective.
Explaination
Cover) with both hands and pull them in and down.
1. Remove outer panel and back-cover.
2. Disconnect all the lead wires from the
drive motor.
3. Remove a screw securing the drive
motor.
4. When replacing the drive motor, be sure
to remount it in the correct position with
the coupler.
5. Connect all the leads to the drive motor.
6. Screw the drive motor to the bracket
motor with a screw driver.
Advertisement
Table of Contents
