JVC KD-NX901 Service Manual page 9

3.1.3 Removing the top chassis assembly
(See Figs.3 to 6)
• Prior to performing the following procedure, remove the front
panel assembly, heat sink.
Reference:
Remove the front panel assembly as required.
(1) From the bottom side of the main body, remove the two
screws C and screw D attaching the top chassis assembly
to the bottom chassis assembly. (See Fig.3)
(2) From the both and rear sides of the main body, remove the
six screws E attaching the top chassis assembly to the bot-
tom chassis assembly. (See Figs.4 to 6)
(3) Lift the top chassis assembly in the direction of the arrow,
and disconnect top chassis assembly from the connector
CN601 on the main board. (See Figs.3 and 6)
(4) Take out the top chassis assembly from the bottom chassis
assembly.
Downloaded from www.Manualslib.com manuals search engine
C
Fig.3
Top chassis assembly
Bottom chassis assembly
Fig.4
Top chassis assembly
Bottom chassis assembly
Main board
Fig.5
Top chassis assembly
E
Bottom chassis assembly
Fig.6
Bottom chassis assembly
CN601
C
D
E
E
E
Rear bracket
(No.MA161)1-9