JVC KD-NX901 Service Manual page 24

3.2.10 Removing the DVD pickup assembly
(See Figs.18 to 20)
• Remove the mechanism control board.
(1) From the bottom of the body, turn the feed gear in the di-
rection of the arrow to move the DVD pickup outwards.
(See Fig.18)
(2) Remove the screw J attaching the thrust spring. (See
Fig.18)
(3) Remove the DVD pickup assembly upward on the L.S.gear
side and release from sub shaft at joint s Move the lead
screw of the DVD pickup assembly in the direction of the
arrow to release from joint t. (See Fig.19)
Caution:
• When releasing the lead screw at joint t, the L.S.collar
comes off at the end of the lead screw.
When reassembling, reattach the L.S.collar to the lead
screw and engage joint t. (See Fig.19)
• When reattaching the L.S.collar, reattach it to the point
s of the lead screw, and to the rod (M).
Make sure that the L.S.collar is set on the rod (M)
spring. (See Fig.19)
(4) Remove the screw K attaching the rack spring and rack
plate on the DVD pickup. (See Fig.20)
(5) Pull out the lead screw. (See Fig.20)
Caution:
Perform adjustment after replacing the pickup.
1-24 (No.MA161)
Downloaded from www.Manualslib.com manuals search engine
Feed gear
Thrust spring
DVD Pickup assembly
Fig.18
t
DVD Pickup assembly
Sub shaft
s
Fig.19
K
Rack spring
Rack plate
L.S.collar
DVD Pickup
Fig.20
J
L.S.collar
Rod(M)
Lead screw
L.S.gear
Lead screw