Stopping The Machine; Transporting The Machine - Toro 30672 Operator's Manual

2. Select first gear to drive the machine.
3. Drive machine until the castor wheels contact curb
(Figure 11).
4. Lift the front of the machine by pushing down on the
lower handle (Figure 11).
5. Drive the machine until drive wheels contact the curb
(Figure 11).
6. Lower the front of the machine (Figure 11).
Note: Both drive wheels should contact the curb and
caster wheels straight.
7. At the same time engage the lower control bar and
lift up on the lower handle to drive over the curb
(Figure 10 and Figure 11).
Note: Lifting up on the lower handle will assist driving
the machine up a curb and not spin the drive wheels.
1. Lower control bar engaged
and mower in reverse
2. Pull up to assist machine
Driving Backward up a Curb
1. Disengage the mower blades.
2. Select reverse to drive the machine.
3. Drive the machine until drive wheels contact curb
(Figure 11).
Note: Both drive wheels should contact the curb and
caster wheels straight.
4. At the same time engage lower control bar and lift up
on the lower handle (Figure 10 and Figure 12).
Note: Lifting up on the lower handle will assist driving
the machine up a curb and not spin the drive wheels.
Figure 11
3. Lower control bar engaged
and mower going forward
1. Lower control bar
(engaged)

Stopping the Machine

To stop the machine, pull back on the upper control bar,
release the blade control bail, turn the ignition key to off and
set the parking brake; refer to Setting the Parking Brake in
Setting the Parking Brake (page 14). Remember to remove
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Transporting the Machine

Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting and
marking as required by law. Please carefully read all the safety
instructions. Knowing this information could help you, your
family, pets or bystanders avoid injury.
To transport the machine:
1. Stop the engine, remove the key, set the brake, and
close the fuel valve.
2. Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
3. If using a trailer, secure the trailer to the towing vehicle
and install the safety chains.
17
Figure 12
2. Handle