Installing The Steering Wheel - Toro 73470 Setup Instructions

Installing the Steering Wheel

1. Install the boot washer onto the steering shaft
(Fig. 2).
2. Remove the plastic trim cover from the steering
wheel (Fig. 2)
3. Install the steering wheel onto the shaft,
carefully aligning the splines (Fig. 2).
Note: On manual steering models, be sure to
align steering wheel in the straight
ahead position. There is no fixed
straight ahead position on power
steering models.
4. Secure the steering wheel to the shaft with a lock
washer and nut (Fig. 2). Tighten the retaining nut
to 45–50 ft–lbs.
5. Install the trim cover on the steering wheel.
6
3
1
2
Figure 2
1. Boot washer
2. Steering shaft
3. Steering wheel
Set-Up Instructions
5
4
m–2482
4. Lock washer
5. Nut
6. Trim cover
3