Test Driving The Tractor - Toro 73470 Setup Instructions

Set-Up Instructions

Test Driving the Tractor

1. Check the oil level in the crankcase (refer to
Engine Oil in your tractor Operator's Manual for
oil type, viscosity and crankcase capacity).
Note: When checking the oil level, slide the
dipstick all the way into the filler tube,
but do not screw the dipstick onto the
filler tube.
2. Check the oil level in the transaxle (refer to
Transaxle Fluid in your tractor Operator's
Manual for oil type, viscosity and capacity).
3. Check to make sure all lubrication points have
been greased as shown in the Maintenance
section of tractor Operator's Manual.
4. Fill the tank with unleaded regular gasoline with
an octane rating of at least 85. Open the fuel
shutoff valve and check the fuel hose and fittings
for leaks.
8
5. As applicable, check and test the operation of the
following:
Engine, choke and throttle controls
Gauges
Headlights and taillights
Indicator lights
PTO clutch and brake
Lift system
Service and parking brakes
Transmission controls
Steering
Tractor operation in forward and reverse
6. Test the operation of the safety interlock system
(refer to the tractor Operator's Manual for the
correct procedure).