Removing The Mower From Storage - Toro 20655 Operator's Manual

Figure 48
3. Raise the handle to the vertical position (Figure 49).
Figure 49
4. Push in on the lower left handle leg until the handle
moves freely forward.
5. Rotate the handle forward (Figure 50).
Figure 50
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
6. Loosen the handle knobs until you can move the upper
handle freely (Figure 51).
Figure 51
7. Fold the upper handle rearward as shown (Figure 52).
Figure 52
Important: Route the cables to the outside of the
handle knobs as you unfold the upper handle.
8. To unfold the handle, refer to Unfolding the Handle.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine rapidly using
the starter to blow the excess oil from the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N·m).
3. Charge the battery (model 20656 only).
4. Connect the wire to the spark plug.
17