Adjusting The Cutting Height; Adjusting The Handle Height; Starting The Engine - Toro 20655 Operator's Manual

Adjusting the Cutting Height

Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
•
Stop the engine and wait for all moving parts to
stop.
•
Do not put your fingers under the housing when
adjusting the cutting height.
Adjust the cutting height as desired. Set all four wheels to
the same height (Figure 13).
Figure 13

Adjusting the Handle Height

Squeeze the bottom of the handle halves together (Figure
14) and change the handle holes in which the pins are
mounted, as follows.
Figure 14
1. Raise the handle

Starting the Engine

1. Firmly push in the primer 3 times with your thumb,
holding the primer in for a second before releasing it
each time (Figure 15).
Figure 15
Note: If the air temperature is below 55°F (13°C),
firmly push the primer in 5 times.
2. Hold the blade control bar against the handle (Figure
16).
Figure 16
1. Blade control bar
3. Start the engine using either the ignition key (model
20656 only) (Figure 17) or the recoil starter (Figure 18).
8
2. Lower the handle