Back Panel; Receiver Output Level - Shure ULX-D User Manual

Back Panel

① RF Antenna Diversity Input Jack (2)
For antenna A and antenna B.
② Power Supply Jack
Connect the supplied 15 V DC external power supply
③ Network Speed LED (Amber)
- Off = 10 Mbps
- On = 100 Mbps
④ Ethernet Port
Connect to an Ethernet network to enable remote control and monitoring
⑤ Network Status LED (Green)
- Off = no network link
- On = network link active
- Flashing = network link active, flash rate corresponds to traffic volume
⑥ Mic/Line Switch
Applies a 30 dB pad in mic position (XLR output only)
⑦ Balanced XLR Audio Output
Connect to a mic or line level input
⑧ Balanced 1/4" (6.35 mm) TRS Audio Output
Connect to a mic or line level input
Transmitters
① Power LED
- Green = unit is powered on
- Red = low battery or battery error (see Troubleshooting)
- Amber = power switch is disabled
② On/Off Switch
Powers the unit on or off.
③ SMA Connector
Connection point for RF antenna.
④ LCD Display:
View menu screens and settings. Press any control button to activate the
backlight.
⑤ Infrared (IR) Port
Align with the receiver IR port during an IR Sync for automated
transmitter programming.
⑥ Menu Navigation Buttons
Use to navigate through parameter menus and change values.
Acts as a 'back' button to return to previous menus or
exit
parameters without confirming a value change
Enters menu screens and confirms parameter changes
enter
▼▲ Use to scroll through menu screens and to change
parameter values
⑦ Battery Compartment
Requires Shure SB900 rechargeable battery or 2 AA batteries.
⑧ AA Battery Adapter
- Handheld: rotate and store in the battery compartment to use a Shure SB900
battery
- Bodypack: remove to accommodate a Shure SB900 battery
⑨ Bodypack Antenna
For RF signal transmission.
10
ULXD4
www.shure.com
12V OUT
15V 0.6A
150 mA
antenna . B power
1 2 3 4 5

Receiver Output Level

The following table describes the typical total system gain from the audio input to the
receiver outputs:
Receiver Output Gain
Output Jack
1/4" TRS
XLR (line setting)
XLR (mic setting)
*This setting matches a typical wired SM58 audio signal level.
ULXD1
⑩ Integrated Antenna
For RF signal transmission.
⑪ Microphone Cartridge
See Optional Accessories for a list of compatible cartridges.
⑫ TA4M Input Jack
Connects to a 4-Pin Mini Connector (TA4F) microphone or instrument
cable.
line
mic
12V
mic / line inst / aux antenna . A
6 7 8
System Gain (gain control =
0dB)
+18 dB
+24 dB
-6 dB*
ULXD2
on
OUT
150 mA
1