Fuses And Circuit Breaker; Servicing The Brake System - Toro 30582 Groundsmaster 580-D Operator's Manual

Warning
Incorrect battery cable routing could damage the
tractor and cables, causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always reconnect the positive (red) battery cable
before reconnecting the negative (black) cable.
4. Remove negative (–) battery cable connectors from
batteries (Fig. 55). Connect a 3 to 4 amp. battery
charger to the posts. Charge the batteries at a rate of 3 to
4 Amperes for 4 to 8 hours.
Warning
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from the battery.
5. When batteries are fully charged, disconnect charger
from electrical outlet and battery posts.
6. Connect negative (–) cable ends, slide tray back in
place, and secure with capscrews. Install side panel,
close hood and secure both with latches.

Fuses and Circuit Breaker

Fuses and fusible links are incorporated for the protection
of the entire wiring circuit. The fuses are located under the
control panel to the right of the seat (Fig. 56). The fusible
links, locate throughout the wire harness, can be replaced if
total loss of electrical function results. If total loss of
electrical function occurs, find and correct the malfunction
before replacing the fusible links.
1. Fuse block (2)

Servicing the Brake System

Check brake fluid level every 50 hours operation. Replace
fluid every 1000 hours operation, or yearly. Replenish
system with DOT 3 hydraulic brake fluid. To check fluid
level:
1. Raise floor panel in front of seat (Fig. 57). Remove tool
tray.
1. Floor plate
2. Snap cover bail off cover and remove cover from
master cylinder (Fig. 58).
48
1
Figure 56
2
1
Figure 57
2. Tool tray