Table of Contents
Advertisement
Assembly
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
DESCRIPTION
Screws
Locknuts
Washers
Discharge chute
Chute handle
Ignition key
Unfolding the Handle
1. Cut the tie that secures the rotor control cable (Fig. 2) to
the handle.
3
2
1
Figure 2
1. Rotor control cable
2. Control bar
Important
If you do not cut the tie, the rotor blades
will not function properly.
2. Loosen the knobs and pull out the handle locks until the
upper handle rotates freely (Fig. 3).
QTY.
4
m-5053
3. Traction drive cable
4. Handle
3
3
3
Installing the discharge chute
1
1
1
Starting and stopping the engine
5
4
Figure 3
1. Knob (2)
2. Cable guide
3. Traction drive cable
3. Position the upper handle as shown in Figure 4.
Figure 4
4. Fully insert the handle locks (Fig. 3).
5. Ensure that the cable guide is in position as shown in
Figure 3.
6. Tighten the knobs until they are snug.
7
USE
1
2
3
m-5072
4. Handle lock (2)
5. Upper handle (right side)
m-5046
Advertisement
Table of Contents
