Adjusting The Lift And Mow Pedal Height; Leveling The Lift And Mow Pedals - Toro 04351 Greensmaster 3050 Operator's Manual

2
Figure 44
1. Mounting capscrews
Adjusting the Lift and Mow
Pedal Height
To gain proper spool travel in the valve bank, adjust the lift
and mow pedals to equal heights as follows:
1. Place 1, 2, and 3 spools in neutral (center of travel) and
remove the transfer rod guard from the foot panel
(Fig. 45).
Figure 45
1. Transfer rod guard
2. Loosen the jam nut securing the yoke on the front of the
long control rod. Remove the cotter pin and clevis pin.
3. Move the adjustment lever by hand to level the mow
and lift pedals and adjust the yoke on the control rod
until the hole in the yoke lines up with the adjustment
lever hole (Fig. 46).
1
2. Cam blocks
1
2
4
Figure 46
1. Jam nut
2. Yoke
Leveling the Lift and Mow
Pedals
If the lift and mow pedals are not level when they are in the
neutral position, an adjustment to the lift pivot is required.
1. Loosen the nut on the back side of the lift pivot
(Fig. 47).
2
Figure 47
1. Lift pivot
2. Rotate the eccentric screw (Fig. 47) to raise or lower the
lift pivot spring, leveling the lift pivot and pedals.
3. While holding the screw, tighten the nut locking the
adjustment.
34
1 3
3. Control rod
4. Adjustment lever
1
2. Eccentric screw