Mounting The Cover; Installing The Battery - Toro 04351 Greensmaster 3050 Operator's Manual

2
Figure 7
1. Capscrew and washer
2. Steering arm

Mounting the Cover

1. Align the cover mounting holes with the holes in the
frame tube and mounting bracket (Fig. 8).
1
3
Figure 8
Shown with steering arm removed
1. Cover
2. Mounting bracket
2. Loosely secure the rear of the cover to the top of the
mounting bracket with a socket head screw (1/4 x
3/4 in.), washer (1/4 in.), and a locknut (1/4 in.) (Fig. 8).
3. Loosely secure the front of the cover to the frame tube
with two self tapping screws (Fig. 8). Tighten all of the
cover mounting fasteners.
1
3
3. Frame bracket
2
3. Frame tube
14

Installing the Battery

1. Mount the battery with the battery terminals toward the
hydraulic tank on the machine.
Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
• Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
2. Connect the positive battery cable (red) from the starter
solenoid to the positive post (+) of the battery (Fig. 9).
Secure it with a wrench and coat the terminal with
petroleum jelly. Make sure the cable will clear the seat,
in the rear-most position, which could cause wear or
damage to the cable.
1
Figure 9
1. Negative (–)
3. Connect the black ground cable from the engine base to
the negative (–) post of the battery. Secure it with a
wrench and coat the terminal with petroleum jelly.
4. Install the battery clamp and washers and secure them
with the wing nuts.
5. Place the terminal cover over the positive (+) and
negative (–) battery posts.
2
2. Positive (+)